F O R M A T These settings are for the version of Skeinforge bundled with ReplicatorG 0017. All of my profiles use a feedrate of 255 PWM as my motor is broken and doesn't extrude at lower power settings.

Commit messages are usually of the format: F(feed rate) WT(width/thickness) L(layer height)

P R O F I L E S

c u p c a k e - f a s t - h i g h r e s

This profile is currently best for printing low-detail, large-volume objects. The layer height is low and the feed rate is high. Walls and surfaces are water-tight. Holes, circles and towers currently are very poor.

c u p c a k e - s l o w - l o r e s

This profile is best for objects with significant complexity: holes are dealt with okay and towers are slightly blobby but not bad. Circles are excellent with this profile.