pyOSC v0.1 Erdem U. Altinyurt 2010(c) GPLv2 license

Frirstly you needed to install this libraries:

1. Python > v2.6 (www.wxpython.org) but not Python 3
2. Python's wx library ( www.wxpython.org )
3. pyusb 1 alpha ( pyusb.sourceforge.net )
4. libusb1 (it's installed default on most distros)

Than you needed to give read/write access to your USB device. It's on 4th bus and 4.th device my current setup (as 0461:0020 Primax Electronics, Ltd ). Adjust numbers after "sudo chmod o+wr /dev/bus/usb/..." ,depending on your setup, or run the script as a root!

dummy@user:/home/dummy/pyOSC> lsusb Bus 003 Device 004: ID 09da:8090 A4 Tech Co., Ltd Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 003 Device 003: ID 067b:2303 Prolific Technology, Inc. PL2303 Serial Port Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 004 Device 004: ID 0461:0020 Primax Electronics, Ltd Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 006 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Bus 007 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub

dummy@user:/home/dummy/pyOSC> sudo chmod o+wr /dev/bus/usb/004/004

Script could run under macOSX and Windows too. But on windows, I think there is no libusb1