Home > testmega

testmega

Testmega is a project mainly written in C and D, it's free.

Test soft for ATmega node

115200, no parity check, 8 data bits, 1 stop bit, no flow control.Setup control by DIP switches as follows.Use DIP switches 1 to 4.

kHz]

0 0000 20 40

1 0001 2,4 4,8

2 0010 2,4 36

3 0011 4,8 4,8

4 0100 4,8 45

5 0101 10 5

6 0110 10 40

7 0111 20 10

8 1000 40 20

9 1001 40 40

10 1010 100 50

11 1011 100 300

Supported commands:

D - read all 128 registers of RFM22

R xx - read register content on address xx, where xx is in hex

W xx yy - write yy value on address xx, where xx and yy are in hex

S - stop TX, go to READY mode

T - start TX

F - select frequency modulation (FSK)

G - select gaussian frequency modulation (GFSK, BT=0.5)

O - select discrete amplitude modulation (ASK,OOK)

C - select carrier only (CW)

P - transmit with modulation source ->data from PN9 random number generator

N - transmit with modulation source ->data from internal buffer

1 - test packet mode-> start transmitting packets of predefined structure

2 - test packet mode-> start receiving packets of predefined structure

Previous:kopfrechnen